Primary Instruments

Primary Instruments

Primary Flight Instruments - Operating Parameters
Auto-Trim Test Switch	Airspeed Indicator	HSI/Nav Control Panel
Attitude Indicator	Autopilot Altitude Control	Altimeter
Outside Air Temperature	Turn Coordinator	Vertical Speed Indicator
Clock	RMI	HSI/NAV Display
	Radar Altimeter

If the Reality XP Jetline instrument option has been selected on the Load Manager a hotspot is also created as illustrated left, which will toggle the RTU panel view.

Reality XP configurations will also permit click-zooming on the individual instruments...a Reality XP option. This is done for you automatically by the Load Manager. See the Load Manager documentation for more details.

Auto-Trim Test	Airspeed Indicator	Altimeter

	Airspeed is intended for registering KIAS (Indicated Airspeed), as any real-world aircraft would. Use of the "True Airspeed" feature in FS is far from reality, and is not supported.	Kohlsman setting according to Pressure Altitude.

Attitude Indicator	Autopilot Altitude Control

When the Flight Director is active, the command bars will appear. When the autopilot is active, the command bars will point to the direction and/or altitude selected on the autopilot.

If the autopilot is not engaged, and an FS flight plan is active, the waypoint bearing will override the NAV or HDG functions. Otherwise, the command bars will continue to respond to the NAV and HDG functions even when the autopilot is not engaged.

Also, when on final approach and an ILS frequency is tuned on NAV 1, the command bars will respond as you intercept the localizer.

Outside Air Temperature	Turn Coordinator	Vertical Speed Indicator

The toggle selector switches the display between outside temperature and cabin temperature.

Clock	RMI

Radar Altimeter

HSI/NAV Display

There are three modes of operation for the HSI/Nav display. These modes are selected via the control panel located on top of the attitude display. The display parameters are described below:

HSI Mode	Arc Mode

Data Mode